Miranda Kaleido-X Manual de instalación descargar pdf (Pagina 52)

Kaleido-X (14RU) Expansion

KXO-EXP-R

The front panel (KXO-EXP-F) is complemented by a rear panel that provides all input and

output connectors associated with the card.

The table below describes the connectors and switch on the rear panel:

Signal Synchronization

A reference signal can be connected to either Frame A or Frame B to synchronize (genlock)

the two-frame system. For redundancy, connect both.

Software

XAdmin

In addition to its other administrative functions, XAdmin is used to enable the expansion

mode, and define the IP address scheme. Before two Kaleido-X systems are joined, each

frame and its output cards have their own IP addresses. In expansion mode, a single IP

address is assigned for the whole expansion system, and individual IP addresses for the

output cards of both frames are assigned from the same page, in XAdmin.

Connector Connector type Function

EXP LINK 1 Molex 74546-1602 Connects to EXP LINK 1 on second frame using

expansion cable (maximum length = 2 meters)

EXP LINK 2 Molex 74546-1602 Connects to EXP LINK 2 on second frame using

expansion cable (maximum length = 2 meters)

Frame A/B switch — Used to designate master/slave hierarchy:

FRAME A = master, FRAME B = slave

Expansion Link 2 Expansion Link 1 Master/Slave

switch

Bottom of panel Top of panel

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 96 97

Sin comentarios

Miranda Kaleido-X Manual de instalación Pagina 52