Miranda Kaleido-X Manual de instalación descargar pdf (Pagina 34)

Kaleido-X (7RU) Installation

GPI/Genlock Card

All other adjustment, alignment and configuration of this card are accomplished using

external controllers (e.g. the XEdit software), and are documented in their respective

manuals.

GPI/Genlock Card

The KXA-GPI-GEN card provides status monitoring, genlock and GPI I/O interfacing for the

Kaleido-X.

The GPI/Genlock card fits in the Kaleido-X frame. It is complemented by a rear panel

connector KXA-GPI-GEN-R that houses all input and output connectors associated with the

card.

The GPI/Genlock card must be installed in the MAIN slot in the Kaleido-X frame. This slot is

color-coded GREY on the front and rear panel of the frame.

The GPI/Genlock card is connected to the other cards in the Kaleido-X frame through the

frame's internal midplane.

See Card Installation and Replacement on page 14, for

instructions on installing the card and the rear panel.

Rear Panel Connections

External connections to the GPI/Genlock card are made through connectors mounted on

the KXA-GPI-GEN-R rear panel. These connectors carry both input and output signals.

Notes

• Be careful to install the KXA-GPI-GEN-R rear panel in the matching location

at the rear of the frame.

• The GPI/Genlock card and its rear panel can be installed in any order.

• Kaleido-X cards are hot-swappable; it is not necessary to turn off the

multiviewer when installing or exchanging cards.

Bottom of panel Top of panel

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 96 97

Sin comentarios

Miranda Kaleido-X Manual de instalación Pagina 34