Miranda Kaleido-X Manual de instalación descargar pdf (Pagina 17)

Kaleido-X (7RU)

Hardware Description & Installation Manual

•Mouse

• Serial port adapters (one with straight cabling and one with crossover cabling for each

output card in your multiviewer):

Rack-Mount Installation

A Kaleido-X multiviewer may be installed in a standard 19-inch rack, using the proper

screws and washers (not included). The Kaleido-RCP2 Remote Control Panel (optional) may

also be installed in a rack using the optional KRCP-RK2 mounting kit.

For proper ventilation, make sure the front and side panel air vents are not blocked and the

air filter is clean.

Frame and Electrical Installation

Kaleido-X (7RU) is a self-contained unit consisting of a frame, redundant power supplies,

and various input and output cards. The monitor wall displays and external control devices

complete the system.

Frame

The Kaleido-X (7RU) frame is 7 RU high. It incorporates an internal midplane for

interconnecting the cards. Cards are installed from the front of the frame. Each card is

associated with input and/or output connectors which are mounted on a connector panel.

These connector panels are installed from the rear of the frame, in the same horizontal

position as their associated card. The redundant power supplies are installed at the top of

the frame.

The hinged front door can be opened to give access to the cards. A removable retaining bar

across the front of the frame inside the door holds the cards securely in place.

The Kaleido-X (7RU) frame incorporates the following key elements:

• A rack-mountable mechanical framework

• A side-opening, removable door to cover and protect the front of the frame and the

installed cards

• A midplane board that enables inter-card communication

• Slots for installing signal processing cards that plug into the midplane

• Mounting points for rear connector panels

• Redundant power supplies

• Ventilation

The front slots and rear panel connection points are color-coded according to the type of

card that can be located in the slot. The extractor handles on the cards are color-coded to

Part number Adapter cabling RS-422 pinout at the DE-9P connector

1737-3000-102 Straight Controller (SMPTE master) mode

1792-3700-100 Crossover Tributary (SMPTE slave) mode

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 96 97

Sin comentarios

Miranda Kaleido-X Manual de instalación Pagina 17