Miranda Kaleido-X Manual de instalación descargar pdf (Pagina 26)

Kaleido-X (7RU) Installation

Card Installation and Replacement

This section describes the installation of rear connector panels and cards in the Kaleido-X

frame.

Installing a Rear Connector Panel

To install a rear connector panel

1 Remove the blank rear panel or the rear panel from the previously-installed card, using

a screwdriver to loosen the two captive screws.

2 Position the new rear panel in the vacant location so its connectors are aligned with the

corresponding plugs, and push it gently into place so the connectors mate.

3 Secure the panel in place, using a screwdriver to tighten the two captive screws.

Removing a Card

To remove a card

1 Open the front door of the frame and locate the card to be removed.

2 Remove the card retaining bar by unscrewing the captive screw on the right side, and

pulling it out of the slot at the left side.

3 Pull the ends of the two extractor handles out and away from the center of the card,

levering it out of its connector.

4 Grasp the extractor handles, and pull the card gently straight out of the slot.

Installing a Card

To install a card

1 Open the front door of the frame and locate an empty slot appropriate for the card

type.

2 Remove the card retaining bar by unscrewing the captive screw on the right side, and

pulling it out of the slot at the left side.

3 Orient the card so that the labelled and color-coded extractor handle is at the top and

the connectors are toward the frame.

4 Slide the card all the way into the slot until it touches the connectors.

5 Push gently on the extractor handles until the connectors mate and the card is

completely into the slot.

6 Install the card retaining bar by slipping it into the slot on the left side of the frame and

fastening the captive screw on the right side.

Note: The cards are mechanically configured so that it is not possible to

install a card in the wrong slot.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 96 97

Sin comentarios

Miranda Kaleido-X Manual de instalación Pagina 26