Miranda Kaleido-X Manual de instalación descargar pdf (Pagina 36)

Kaleido-X (7RU) Installation

GPI/Genlock Card

GPI Circuits

The individual GPI contacts are reconfigurable as either inputs or outputs. For interfacing

purposes, the input and output circuit configurations are as shown in the following

diagrams:

You should ensure your GPI physical connections are well established. In the following

example, the goal is to trigger a relay and light up a light.

To facilitate cabling of the GPI inputs and outputs, a terminal block adapter is available

separately (order code KXA-TBA-G). The GPI Terminal Block Adapter accommodates up to

24 terminal block connections using positive and negative terminal connections. Each

column on the terminal block has 6 positive and 6 negative terminal connections that

correspond to each pin position. Negative pins (labelled with an N) on the Terminal Block

16 1P 33 2P 50 3P

17 GND 34 GND

CAUTION

In the example below, make sure your P and N connections are in the

proper polarity otherwise your GPI output will always be in the ON state.

Pinout for GPI A, GPI B and GPI C connectors (continued)

Pin Signal Pin Signal Pin Signal

GPI configured as INPUT GPI configured as OUTPUT

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 96 97

Sin comentarios

Miranda Kaleido-X Manual de instalación Pagina 36