Miranda RCP-100 Instrucciones de operaciones descargar pdf (Pagina 10)

GUIDE TO INSTALLATION AND OPERATION

6 | FLO-1601

• Use the keys on the local control panel to step through the displayed menu to configure and adjust

the FLO-1601.

FLO-1601 MENU

STATUS STATUS OK

NO RF INPUT (< -60 dBm)

WEAK RF INPUT (< -55 dBm)

OPTICAL OUT FAIL

RF SIG STRENGTH [-60 dBm, -59 dBm, -58 dBm,….., -1 dBm, 0 dBm] (read-only)

OPTICAL OUT [ON

, OFF]

LNB POWER [OFF

, +13V, +18V]

USER PRESET LOAD [USER 1, USER 2, USER 3, USER 4, USER 5]

SAVE [USER 1, USER 2, USER 3, USER 4, USER 5]

CONFIG ALARMS NO RF INPUT ALARM LEVEL [GREEN, YELLOW, RED, FLASH RED]

ALARM REPORT [NONE, GPI]

WEAK RF INPUT ALARM LEVEL [GREEN, YELLOW, RED, FLASH RED]

ALARM REPORT [NONE, GPI]

OPTICAL OUT FAIL ALARM LEVEL [GREEN, YELLOW, RED, FLASH RED]

ALARM REPORT [NONE, GPI]

VERSION FLO-1601:xxx

FACTORY DEFAULT [RESTORE]

Notes on the menu items:

OPTICAL OUT – turn the laser ON or OFF

LNB POWER – Turn the power sent to the LNB (Low Noise Block Converter) via the RF input connector

OFF, or select the LNB voltage as +13V or +18V.

USER PRESET – the FLO-1601 has 5 registers that can store full configuration data. Use the LOAD and

SAVE menu items to select a register (USER 1 to USER 5) and either save the current configuration into that

CONFIG ALARMS / ALARM LEVEL – for each alarm, set the color that will be displayed on the FLO-1601’s

status LED.

CONFIG ALARMS/ ALARM REPORT – for each alarm, select whether that alarm will be reported on the

Densité frame’s GPI output. See the manual for the frame’s controller card for more information about this

feature.

1 2 ... 5 6 7 8 9 10 11 12

Sin comentarios

Miranda RCP-100 Instrucciones de operaciones Pagina 10