
RCP-BR: Guide to Installation and Operation
Page 62 Miranda Technologies Inc.
4.3.1 Network setup
The network of the RCP-BR panel can be setup to either obtain its network
settings automatically via DHCP or to manually enter a static IP address
3
. The
interface for modifying the network settings is shown in figure 4-16.
Figure 4-16 Network setup
By default the RCP-BR panel uses the DHCP setting. To change this select either
the ‘DHCP’ or ‘Static’ radio buttons and then enter the IP Address, Subnet Mask
and Default Gateway. Having carried out the appropriate changes press the
‘Apply’ button to update the network on the RCP-BR panel. It is not necessary to
restart the RCP-BR panel for these settings to come into effect.
3
Note : The Default Gateway must not be set to 0.0.0.0
Comentarios a estos manuales