Miranda KS-900 Manual de instrucciones descargar pdf (Pagina 10)

GUIDE TO INSTALLATION AND OPERATION

6 | Kaleido-Solo

2.3 RS-422/GPI connections

RS422/GPI Connector

Pin number

Description

RS-422 Tx+

RS-422 Tx-

RS-422 Rx+

GPI Input #1

GPI Input #2

RS-422 Rx-

GPI Ouput

Ground

2.4 Powering up

When powering up the Kaleido-Solo

 The led should turn on red.

 After 5 seconds the led should flash red (no valid SDI input) or green (valid SDI input).

 Your monitor should turn on and you should see content of the SDI input. If you only use the optional optical

input you won‟t be able to see any video until 15 seconds approximately. In this step Kaleido-Solo will use all

factory default parameters for video and audio. Even if you had muted audio you will hear audio in this boot up

step.

 After 15 seconds the led should stop blinking.

 The overlay should appear making the monitor turn off and on once.

 You are now ready to use the Kaleido-Solo.

The average total time to power-up a Kaleido-Solo is 20 seconds.

Note that the screen may turn off and on more than once on some monitor. This is a normal behavior.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 91 92

Sin comentarios

Miranda KS-900 Manual de instrucciones Pagina 10